REDIMON is a 24vdc powered unit which can fully monitor two open circuit momentary devices such as Dado Panic Strip, push buttons or foot switches and gives volt free changeover contacts for both alarm and fault conditions. An end of line resistor (6k8) is fitted at the remote ends of Dado Panic Strip. Pressing the Dado Panic Strip creates a short circuit which will be detected as an alarm condition. If the Dado Panic Strip becomes disconnected in any way a fault condition is generated. An integral reset button is used to reset the unit after an alarm event.
Status LEDs are provided, normally a green LED would be illuminated for system healthy, the red LED indicates an alarm, and alternate flashing of the red and green LEDs would indicate a fault condition.
REDIMON also provides a 24vdc output for driving strips of LEDs in Dado Panic Strip, these LEDs can operate in 3 different ways which is controlled by adjusting the potentiometer.
REDIMON also provides a 12vdc output for driving strips of LEDs in Dado Panic Strip and can be configured to drive the LEDs in 3 different ways.
The REDIMON gives a 24V output for driving strips of LEDs in Dado Panic Strip, these LEDs can operate in 3 different ways which is controlled by adjusting the potentiometer.
Position 2: The LEDs are off then when the unit goes into alarm the LED’s will turn on.
Position 3: The LEDs are off, then when the unit goes into alarm the LEDs will begin to flash.
FAQs | N/A |
---|
Sorry No Video Available
We offer UK Next Day and UK 2-3 Day shipping options on all stock products with Free UK Shipping on orders over 100 GBP before tax.
International delivery rates vary by country.
Please visit our
page for a full explanation of our shipping arrangements.Sorry No FAQs Available